Skip to main content
Book multiple services and get 5% off

Gutters, Fascia & Soffit

The Flush Test and the Camera: How You Know a Gutter Actually Drains

Published 21 September 2026
Updated 21 September 2026

How do you know a gutter is blocked, and not just guess?

Key takeaways

  • Signs from the ground are clues. They tend to show late, and a partial blockage can give none at all.
  • The proof is water: the full run is flushed and tested, and the downpipes are flushed through to the gully.
  • A camera check on the roofline lets you see exactly what came out.
  • Leaking joints, dropped brackets and rotting fascia found along the way are photographed and reported to you.

You put water through it and watch where it goes. Everything short of that is inference. A stain on the render, a drip at a joint or a gutter that overflows in a downpour all suggest a blockage, but they do not tell you where it is, how bad it is, or whether there is a second one further along. On our gutter cleaning in Longford the answer is settled by a flush test and a camera check on the roofline, so the question “was it blocked?” has an answer you can see rather than one you are asked to trust.

Why the signs you can see arrive late

There are useful things to look for from the garden, and they are set out in the “how to tell from the ground” section of why gutters need clearing in an Irish climate. The trouble is timing. The gutter page puts it bluntly: “By the time staining shows on the wall the damage has usually been running for a season or more.”

A gutter can also be partly blocked and still look fine. It copes with ordinary rain, the overflow only happens in the heaviest showers, and those tend to arrive in the dark or when nobody is outside looking up. A dry day tells you very little either way.

Clearing it is only the first half

Gutters, outlets and hoppers are emptied by hand or vacuum, and the debris is bagged and taken away rather than left in the beds. Then comes the test: one of the items listed under what the job covers is the “full run flushed and tested with water.”

The flush test

The flush is the step that turns an opinion into a result. Water goes in along the run, and the downpipes are flushed through until it is confirmed that the water is reaching the gully at the bottom. If it does, the route is open from gutter to ground. If it does not, the blockage is somewhere along that route, and it has been found before anyone has packed up.

The job also checks “joints, brackets and falls” for leaks or sagging: a joint that weeps, a bracket that has dropped, a section that no longer runs towards its outlet.

A clean-looking gutter is a claim. A gutter that has been flushed to the gully is a result.

The camera check on the roofline

Alongside the flush, the gutter clean includes, in the page’s words, “a camera check on the roofline so you see exactly what came out.” That is the honest answer to “did it really need doing?”: you see the scale of what was there for yourself. Beyond that, every job is photographed before and after, so you can see the difference the work made.

What you are told afterwards

The last of the four stages is a report, and the point of it is that you hear what was found, not simply that the work is finished. Failed joints, dropped brackets and rotting fascia are photographed and reported when the job is completed.

Put together, that is three things you are shown rather than told about: what came out of the gutters, the before-and-after photographs, and a photograph of anything along the run that is failing. A blocked gutter stops being a guess at the point where you can see each of those for yourself.

That report is where the value sits. The gutter page treats the clearing as the routine part, and says that catching a dropped bracket or a failed joint while up there “is the valuable part.” A clean gutter on a failing bracket will fill and overflow again at the same low point. Knowing about the bracket is what lets you deal with it.

When the trouble is lower down

Sometimes the flush shows the gutter running freely and the problem sitting further down: water backing up a downpipe or spilling at its foot. Reading those symptoms is covered in our post on a downpipe blocked at the bottom. Either way, a flush test tells you which part of the route the trouble is in, which is the question the ground-level signs cannot answer.

What you see and hear after a gutter clean

How do I know if my gutters are blocked?

Overflow in heavy rain, staining on the wall and drips at the joints are all signs. But the only way to know for certain is to put water through the run and see whether it reaches the gully, which is what a flush test does.

Do you take away what comes out of the gutters?

Yes. The debris is bagged and removed from the site, not dropped into the flowerbeds.

Will I get to see what was in my gutters?

Yes. The roofline gets a camera check so you can see exactly what came out, and every job is photographed before and after.

What happens if a leaking joint is found?

It is photographed and reported to you with the completion of the job, along with any dropped brackets or rotting fascia.

Related services

Written by the Softwash Solutions team

We are an exterior cleaning company based in Longford, working across Westmeath, Roscommon, Leitrim, Cavan, Sligo, Mayo and Galway. Everything here comes from work we actually do on Irish roofs, render and roofline.

Talk to us about your property

Keep reading

Not sure what your property needs?

Tell us what you are looking at, and we will tell you straight.

If the growth on your roof or render is doing damage, we will say so. If it can wait, we will say that too.

Get a free quote